Autodesk Design Suite 3D - Planix Home Design Suite 3D Instrukcja Obsługi Pobierz pdf (Strona 228)

Chapter 6 Creating Cadastral Information

222

If you use polylines to draw parcel geometry, then you must break

crossing polylines before defining the parcels. Also, delete any

duplicate lines that you may have drawn where two parcels abut each

other. You can break crossing lines and erase duplicate lines by using

the AutoCAD Map Cleanup command. For more information, see

“Cleaning Up Maps” in Chapter 8, “AutoCAD Map and AutoCAD

Land Development Desktop.”

Draw Parcel Geometry Based on Area

To draw a parcel so that it is a specific area, use the Parcel Sizing

commands. Simply draw the parcel with only one open segment, and

then use one of the parcel sizing commands to draw the closing

segment.

The following illustration shows how a parcel is defined by using the

Slide Bearing command.

Depending on the parcel settings, these commands can define the

parcel to the parcel database, and they can also label the parcel that is

calculated.

You cannot use the Parcel Sizing commands to edit a parcel that is

already defined to the parcel database. To change a parcel definition,

you must delete the existing parcel definition and redefine the parcel.

For more information about deleting parcels, see “Managing Parcels”

in this chapter.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 284 285

Brak uwag

Autodesk Design Suite 3D - Planix Home Design Suite 3D Instrukcja Obsługi Strona 228